10 AQT-RCS
Instruction Manual
The 'Reading Data from Unit' message will be displayed
during the communication process. After a status
response is received the Headend Status screen will
be displayed. This is a real time data communication
process in which the AQT-RCS is reading the data from
each AQT module and may take a few moments to
complete, please be patient.
Click
Setup
to proceed to the Setup Page - this permits
the entry of the AQT-PCM unit digital addresses into
the AQT-RCS.
The AQT-RCS 'Setup Page' is used to enter headend site information as well as the digital address of each respective PCM unit
connected and deployed in the headend. The digital address of the PCM unit must be entered in order for the AQT-RCS to
communicate correctly in real time.
AQT-RCS Setup Page
Enter the desired information in the upper portion of the 'Setup Page' and click
Save
to apply the information to non-volatile memory.
Use the lower portion (Headend Configuration) to enter, remove and verify AQT units. The digital address of an AQT must be first
entered into the AQT-RCS before it can communicate. The AQT digital address can be displayed by accessing the interactive menu using
the UP/DN arrow navigation keys on the front panel LCD menu of each PCM unit. For more detailed instructions on how to obtain the
serial number of the AQT unit, please refer to pages 16 though 19 in the AQT-Series instruction manual.
AQT-RCS Firmware Version,
MAC Address & Serial Number
(shown for reference only)
Enter the desired headend
Location and Name
Click to Add a
PCM unit
Digital Address and Unit
NOTE:
It is advised to add
units in the order they are
physically located @ the head-
end so that they appear the
same in the Status Page.
Click to Delete a unit
Click to verify PCM unit
address & connection
Click to Save
Setup Changes
Click for Unit
Info Page
Click for Headend
Status Page
Click to Refresh
and Update Page
