Charge on.
BlinkCharging.com
Page 4 of 56
SAVE THESE INSTRUCTIONS
1.
IMPORTANT SAFETY INSTRUCTIONS
Before installing or using the
Blink Charging Co. Its Affiliates and Subsidiaries (“Blink”)
(Blink) electric vehicle
supply equipment (EVSE), read all these instructions, paying particular attention to any WARNING and CAUTION markings
in this document and on the Blink Product. You should also review any instructions included with your electric vehicle (EV) as
they pertain to vehicle charging.
The following symbols and associated instructions are used throughout this document and
relate to action necessary to avoid hazards.
Legend
WARNING
Risk of personal injury
WARNING: RISK OF ELECTRIC SHOCK
Risk of electric shock
WARNING: RISK OF FIRE
Risk of fire
CAUTION
Risk of damage to the equipment
•
This product should be installed only by a qualified approved technician.
•
Blink is not responsible for physical injury, damage to property or equipment caused by the installation of this
device.
•
A device employing pressure terminal connectors for field wiring connections shall be provided with instructions
specifying a range of values or a nominal value of tightening torque to be applied to the clamping screws of the
terminal connectors.
•
Make sure that the materials used, and the installation procedures follow local building codes and safety
standards.
•
The information provided in this manual in no way exempts the user of responsibility to follow all applicable codes
or safety standards.
•
Review this manual carefully and consult with a licensed contractor, licensed electrician, or trained installation
expert to make sure of compliance with local building codes and safety standards.
Repair and Maintenance Clause
•
Only a licensed contractor, licensed electrician, or trained installation expert is allowed to repair or maintain this
device. It is forbidden for a general user to repair or maintain this device.
•
Any repair or maintenance MUST be performed after removing power from this device.
Moving and Storage Instructions
•
Store the product at a temperature between -40 and +80 °C.
•
Check the product for damage after moving.
•
Carry the product by the sides. Do not lift or carry by either the flexible cord or the EV cable, if provided.
