16
• Plug the USB flash drive into the blender’s USB port.
• If the blender is in manual or automatic operation mode, the USB flash drive
menu will automatically load on the LED screen. If the LED screen is already
in programming mode, go to the main menu, touch to scroll to menu item 5
(
USB Flash Drive
), and then touch .
• From the USB flash drive menu, touch to scroll to option 3 (
Export Counts
)
and then touch to select the option. The LED screen will then display the
question
Export counts to the sth-cnts.csv file?
Touch to start the export
process.
• After the export process completes, remove the USB drive from the blender
and secure the USB cover on the USB port with a Phillips screwdriver.
5.4.7 Blender Settings: Enclosure Safety Mode, Standby Time, Blend Cycle
Pause, and Slider Lockout
You also have the option to change various blender settings, including enabling
and disabling the enclosure safety feature, changing the time before the blender
switches to standby mode, enabling and disabling the blend cycle pause function,
and enabling and disabling the slider lockout. These features are discussed below.
5.4.7.1 Enclosure Safety Mode
The enclosure safety feature prompts you to ensure the sound enclosure lid is
closed during motor operation. When the enclosure safety mode is enabled, if you
touch a control surface button to begin motor operation and the sound enclosure
lid is not closed, the LED screen will show the message
The lid is open. Start
blender?
Close the lid to begin motor operation; or, to start the blender with the
lid open, touch . When you begin motor operation with the sound enclosure lid
closed, if you then raise the lid during operation, the motor will turn off.
To enable or disable the enclosure safety feature, complete the following steps:
• Enter programming mode by touching and holding for 3 seconds. The
control surface will display and , and the LED screen will show the main
menu.
• Touch to scroll to menu item 6 (
Settings
), and then touch .
• Select option 1 (
Enclosure Safety Mode
) by touching .
• Touch to toggle between disabling and enabling the enclosure safety
feature.
• Touch to return to the previous menu.
5.4.7.2 Screen Standby Time
You can change the length of time before the blender switches to standby mode
(15 minutes, 1 hour, 6 hours, or 12 hours). To select a new standby time, complete
the following steps:
• Enter programming mode by touching and holding for 3 seconds. The
control surface will display and , and the LED screen will show the main
menu.
• Touch to scroll to menu item 6 (
Settings
), and then touch .
