2.
Internal HDD Installation
The specifications for the Internal Hard Drive must be the following:
•
Size: 3,5”
•
Minimum RPM 7200
•
Maximum capacity of 6TB.
•
We recommended to use optimized HDD for surveillance as “Western Digital
Purple” or “Seagate Surveillance HDD”.
We strongly do not recommend to use a standard PC HDD,
since a standard HDD is not
ready to work 24/7 and the HDD might stop working due to the very high workload.
IMPORTANT: Using a standard HDD for 24/7 surveillance could lead to Hard disk failures and data
loss.
1. Loosen the 4 screws from
the bottom of the NVR. And
remove the top cover.
2. Screw the 4 included HDD
mounting screws into the HDD
3. Turn the device upside-
down and let the screws slide
into the mounting holes then
secure the 4 HDD mounting
screws firmly.
4. Connect the Serial ATA data
cable and the Serial ATA
power cable to the
corresponding ports.
5. Connect the Serial ATA data
and the Serial ATA power
cables to the HDD accordingly.
When plugged in correctly, the
cable snaps in.
6. Place the top cover back and
fix the 4 screws from the
bottom of the NVR.
Important! If the HDD needs to be replaced or dismounted: Shut down the
NVR and then unplug the power cable before you open the case to replace the
HDD.