Blastrac EBE 350 VH, Operating Instructions Manual

Page: 48 / 99

Operating Instructions EBE 350 VH
Operation
6.1 Operation
Normal start-up and operation of the blast machine EBE 350 VH is no
different from the procedure described in Chapter 5 “Initial operation”.
Carry out blasting in parallel tracks in such a way that the dust hose
and electric cable do not become twisted.
The selection of the correct advancing speed of the blast machine is
important for a good blast result. In the case that the surface has
different characteristics (e.g. different hardness or different coating
thicknesses), a uniform blast result can be achieved by varying the
advancing speed during blast cleaning.
6.2 Switching-off the machine
ˆ Shut off the abrasive supply by pushing the “Shot control -“
button on the remote control box until the shot valve is
completely closed.
ˆ Press the push button "Main blast OFF" on the remote control
box. This switches off the blast wheel motor.
ˆ Press the push button "Elevator OFF" on the main box at the
rear of the blast cleaning machine. This switches off the elevator
motor.
ˆ
Set the main switch on the main box at the rear of the blast
cleaning machine to "OFF".
ˆ After several minutes press the push buttons "Compressor OFF",
“Fan OFF” and "Pulsator OFF" on the filter unit.
ˆ Set the main switch of the filter unit to "OFF".
2