39
12x PTZ Outdoor Camera User Manual
SECTION 4: USING THE OSD MENUS
•
Proportional Panning
. When this function is enabled, the pan/tilt speed changes according to the amount of zoom. If
using high zoom, the pan/tilt speed is slowed to keep the image from moving too fast on the live view display. You can set
PROPORTIONAL PAN to ON or OFF to enable/disable the function. This function is enabled automatically while setting patterns.
Park time and actions
This feature allows the camera to start a predefined action (park action: scan, preset, pattern, etc.) automatically after a period of
inactivity (park time).
You can set PARK TIME from 5 to 720 seconds and set the park action (PARK ACT) as preset 1 to 8, pattern 1 to 4, patrol 1 to 8, pan
scan, tilt scan, random scan, frame scan, panoramic scan, day mode, night mode or none.
NOTE
If a control signal is not received after the park time, no park actions is performed when either of these conditions exist:
•
In the process of performing dome actions by calling special presets
•
In the process of performing external alarm linked actions
Image freeze
This feature enables the live view to switch directly from one scene defined by a preset to another, without showing the middle
areas between these two, to ensure the surveillance efficiency. It can also reduce the use of bandwidth in a digital network system.
To enable this function, set IMAGE FREEZE to ON.
•
PTZ speed
. You can define the speed of the dome movements.
a.
DOME SPEED
: the manual movement speed can be set to HIGH, MID or LOW.
b.
SCAN SPEED
: scan speed defines the scan degree per second of a panning scan, tilting scan, frame scan, random scan
and panoramic scan. Scan speed is adjustable from 1 to 40 degrees per second.
c.
PRESET SPEED
: the speed of calling a preset can be set from level 1 to 8. The higher levels will call a preset faster.
•
Limit stops
. The camera can be programmed to move within the configurable limit stops (left/right, up/down). To set these
limits:
a.
Move the cursor to LIMIT STOPS and click
IRIS+
to set it ON to enable this feature. Click
IRIS+
again to confirm.
b.
Move the cursor to
SETTING STOPS,
then
IRIS+
. The message
SET LEFT LIMIT
will appear.
c.
Click the direction buttons in the PTZ panel to configure the left limit stop. Click
IRIS+
to confirm.
