PZL 104 Wilga
.
Item code: BH156.
Instruction Manual
6
II. INSTALLING THE FLAP
Flap install as same as the way of aileron. Repeat
step #1 - #4 on the part I
(page 4,5)
to install the flap.
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
Flaslink
Pushrod wire Control horn
Bend and cut.
Silicone Tube
See pictures below:
III. INSTALLING THE ENGINE MOUNT
OPTION 1: ELECTRIC MOTOR
See pictures below:
There are two options:
1. Electric motor
2. Engine mount.
4x70mm
4x20mm
