PZL 104 Wilga
.
Item code: BH156.
Instruction Manual
5
3)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
4)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
Drill a hole
1.5mm
Secure
Electric wire
Electric wire
2x10mm
Secure
5)
Repeat the procedure to install the aileron servos
in the opposite wing half.
3. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the bot-
tom of the aileron.
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
4. INSTALLING THE AILERON LINKAGES
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2
lock nut
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
3) Repeat the procedure to install the control horn
on the opposite aileron.
1. A+B Epoxy glue
2. Push in
Aileron
control horn
