PZL 104 Wilga
.
Item code: BH156.
Instruction Manual
10
1. ELEVATOR CONTROL HORN
INSTALLATION
Elevator control horn install as same as the way of
aileron control horn. Please see pictures below.
When you are sure that everything is aligned correctly,
mix up a generous amount of 30 minute epoxy.
Apply a thin layer to the top and bottom of the stabilizer
mounting area and to the stabilizer mounting platform
sides in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measurements one
more time before the epoxy cures. Remove any ex-
cess epoxy using a paper towel and rubbing alcohol
and hold the stabilizer in place with T-pins or masking
tape.
Bottom side.
control horn
1. A+B Epoxy glue
2. Push in
A/B Epoxy glue
Top side.
4x15mm
Secure
Drill a hole
1.5 mm
Elevator control horn
2. ELEVATOR PUSHROD INSTALLATION
VI. THE TAIL WHEEL BRACKET,
RUDDER INSTALLATION
Rudder install as same as the way of elevator.
M2 Lock nut
M2
Silicone Tube
Elevator servo
Elevator pushrod
Connector
Servo arm
Secure
Cut
