PZL 104 Wilga
.
Item code: BH156.
Instruction Manual
4
I. AILERON
See pictures below:
REPLACEMENT SMALL PARTS
Temporary pin to
keep hinge centered.
1. INSTALLING THE AILERONS
Test fit the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
2. INSTALLING THE AILERON SERVOS
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Servo tray
Remove the covering
Bottom side.
Aileron
Flap
Top side.
C.A glue
C.A glue
Assemble then apply
drops of thin C/A to center
of hinge,on both sides.
1. Aluminium landing gear.
2. Wheels.
3. Tail gear set.
4. Spinner
5. Fuel tank.
5a. Clunk.
5b. Stopper (three line).
6. Wood - motor mount.
7. Plastic - engine mount.
2x10mm
4x70mm
3x12mm
6
4
5
5a
5b
4x20mm
4x15mm
4x15mm
3x15mm
5x35mm
2
1
1
3
4x30mm
7
