PZL 104 Wilga
.
Item code: BH156.
Instruction Manual
14
Secure
Secure
Locate the aluminium wing dihedral brace.
XI. WING ATTACHMENT
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
Attach the aluminium tube into the fuselage.
622mm
Aluminium tube.
19mm.
Insert the wing panel as pictures below.
Push in
Push in
Push in
Screw the wing panel in position.
3x12mm
Secure
3x12mm
Drill four holes 2.5mm
on the right and left side.
3)
Slide the cowl back over the engine and secure
it in place using four wood screws. See picture below.
4)
Install the muffler and muffler extension onto
the engine and make the cutout in the cowl for muffler
clearance. Connect the fuel and pressure lines to the
carburetor, muffler and fuel filler valve.
Drill four 2.5mm pilot holes through both the cowl and
the side edges of the firewall. Using a 3mm drill bit,
enlarge the four holes in the cowling.
XII. INSTALLING PROPELLERS
Please see pictures below.
