![background image](http://html1.mh-extra.com/html/black-decker-1/lcsb2140/lcsb2140_instruction-manual_2766070004.webp)
. Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
. Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
SAVE THESE INSTRUCTIONS
• The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
mW ..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
or DC ...direct current
no ................no load speed
................Class I Construction
(grounded)
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
................. Use proper respiratory
protection
.................Read instruction manual before use
................Use proper eye protection
...................Use proper hearing
protection
•
USE Of ExTENSION CORDS
Make
sure the extension cord is in good
condition before using. Always use
the proper size extension cords with
the tool – that is, proper wire size for
various lengths of cord and heavy
enough to carry the current the tool will
draw. Use of an undersized cord will
cause a drop in line voltage resulting
in loss of power and overheating. For
proper size cords see chart below.
4
• Never operate the snow mover without
good visibility or light. Always be sure
of your footing, and keep a firm hold on
the handles. Walk; never run.
cleaRing a clogged
dischaRge chute
WARNING:
Hand contact with the
rotating impeller inside the discharge chute
is the most common cause of injury
associated with snow movers. Never use
your hand to clean out the discharge chute.
To clear the chute:
1. Shut off motor, release bail handle
and remove safety key.
2. Wait 10 seconds to be sure the
impeller blades have stopped rotating.
3. Always use a clean-out tool, not your hands.
maintenance and stoRage
• Check shear bolts and other bolts at
frequent intervals for proper tightness
to be sure the equipment is in safe
working condition.
• Always refer to the instruction manual
for important details if the snow mover
is to be stored for an extended period.
• Maintain or replace safety and
instruction labels, as necessary.
• Run the machine a few minutes after throwing
snow to prevent freeze-up of the auger.
This Class B digital apparatus complies
with Canadian ICES-003. This device
complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NOTE:
This equipment has been tested
and found to comply with the limits
for Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the
equipment and the receiver.
minimum Gage for Cord Sets
Volts Total length of Cord in feet
120V 0-25 26-50
51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
More Not more
American Wire Gage
Than Than
0 - 6 18 16
16 14
6 - 10 18
16
14 12
10 - 12 16
16
14 12
12 - 16 14
12 Not Recommended