Black+Decker BCNG01D1, Manual

Page: 9 / 40

9
ENGLISH (Original instructions)
To install battery pack (Fig. A)
u
Insert battery pack firmly into tool until an audible click is
heard as shown in figure A. Ensure battery pack is fully
seated and fully latched into position.
To remove battery pack (Fig. B)
u
Depress the battery release button (11b) as shown in
figure B and pull battery pack out of tool.
Operation
Warning! Read the section titled Nailer Safety Warnings at
the beginning of this manual. Always wear eye and ear
protection when operating this tool.
Keep the nailer pointed away from yourself and others. For
safe operation, complete the following procedures and checks
before each use of the nailer.
Warning! To reduce the risk of personal injury, disconnect
battery pack from tool and engage trigger lock-off before
performing maintenance, clearing a jammed nails, leaving
work area, moving tool to another location or handing the tool
to another person.
Warning! Keep fingers AWAY from trigger when not driving
fasteners to avoid accidental firing. Never carry tool with finger
on trigger.
u
Wear proper eye, hearing and respiratory protection.
u
Remove battery pack from tool and engage trigger lock-
off.
u
Lock the pusher in the back position and remove all nail
strips from the magazine.
u
Check for smooth and proper operation of contact trip and
pusher assemblies.
Do not use tool if either assembly is not functioning
properly.
u
Never use a tool that has damaged parts.
Warning! Operate the tool with fasteners at a rate not exceed
30 times/min.
To operate the nailer
Warning! The contact trip needs to be depressed followed by
a full trigger pull for each nail followed by a release of both the
contact trip and trigger after each nail.
Warning! The battery should always be removed and the
trigger lock-off engaged whenever any adjustments are made
or when tool is not in use.
u
Fully depress contact trip against the work surface.
u
Fully pull trigger and motor will start. (nail will drive into
work surface).
u
Release trigger.
u
Lift contact trip off work surface.
u
Repeat the above 4 steps for next application.
Preparing the tool
Warning! NEVER spray or in any other way apply oil, lubri-
cants or cleaning solvents inside the tool. This can seriously
affect the life and performance of the tool.
Warning! The battery should always be removed and the
trigger lock-off engaged whenever any adjustments are made
or when tool is not in use.
u
Read the Safety Instruction section of this manual.
u
Wear eye and ear protection.
u
Remove battery from tool and fully charge.
u
Ensure magazine is empty of all fasteners.
u
Check for smooth and proper operation of contact trip and
pusher assemblies. Do not use tool if either assembly is
not functioning properly.
u
Keep tool pointed away from yourself and others.
u
Insert fully charged battery pack.
Correct hand position (Fig. C)
Warning! To reduce the risk of serious personal injury,
ALWAYS use correct hand position as shown in figure C.
Warning! To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle.
Adjusting Depth (Fig. D)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel (3) on the side of the tool.
Warning! To reduce risk of serious injury from accidental
actuation when attempting to adjust depth, Always:
u
Remove battery pack.
u
Engage trigger lock-off.
u
Avoid contact with trigger during adjustments.
Depth settings are on a sliding scale (4). The left side indicat-
ing the deepest and the right side indicating the shallowest.
u
To drive a nail deeper, rotate the depth adjustment wheel
(3) downwards. This will slide the depth adjustment indica-
tor (4) to the left on the scale.
u
To drive a nail shallower, rotate the depth adjustment
wheel (3) upwards. This will slide the depth adjustment
indicator (4) to the right on the scale.
Loading and unloading the tool (Fig. E,F)
Warning! Keep the tool pointed away from yourself and oth-
ers. Serious personal injury may result.
Warning
!
Never load nails with the contact trip or trigger
activated.
Warning
!
Always remove battery pack before loading or
unloading nails.
Warning
!
The battery should always be removed and the
trigger lock-off engaged whenever any adjustments are made
or when tool is not in use.