Black Box PI9120A, User Manual

Page: 22 / 41

22
INTELLIGENT PRINTER SWITCH
PLUS
4.5 Command-Line Options
ADMENU supports a number of command-line options that allow the utility
to be installed and run in several different formats. They also allow you to
change a number of default settings and to select different hotkey
combinations. Command options are preceded by a slash character on the
command line. Any number of options can be specified. For example, the
following command line would install the utility for use in text modes with
LPT2 as the default port and
<CTRL><SHIFT> as the hotkey combination:
ADMENU /T /L2 /H2
The rest of this section is a summary of all the options. The default settings
(shown in parentheses) are assumed for all options that you do not specify.
/U
(No default)
Deletes the utility from memory.
/T and /G
(/G default)
The /G option allows use of the resident software in both text and graphics
modes. When installed with the /G option, the software will occupy 22 KB
of memory. Software installed with the /T option allows ADMENU to be
used in text modes only and the memory requirement is reduced to 10 KB.
The memory size used is confirmed in the installation message.
/Lx and /Cx
(/L1 default) x=1, 2, or 3
These options specify the PC port that is displayed when the ADMENU
software is initially invoked (any of LPT1, LPT2, LPT3, COM1, or COM2).
The number of the required port (serial or parallel) is specified after the
letters L or C respectively. The port to be used can be specified once the
software has been invoked using the PC PORT function, so these options
are primarily for convenience only.