Black Box LWS100AE, Manual

Page: 14 / 68

LWS100A/LWS100AE User’s Manual
14
2.6 Plug in RS232 Cable
Connect PC/NB to the LWS100A/LWS100AE serial port by using an NULL cross cable with DB9 female
connector. This PC/NB will be used to configure LWS100A/LWS100AE via command mode. A NULL cross
cable will cross pins 2 & 3, 7 & 8, and 4 & 6. LWS100A/LWS100AE can be configured either by web browser
or by command mode.
2.7 Plug in Power Cable
Plug the power cord of power adapter into the socket marked with “DC IN” on the rear panel of
LWS100A/LWS100AE, and plug the power adapter into an A/C power outlet. When completed, the green power
LED on the top panel should light up.
Warning: Use only power adapter supplied with the LWS100A/LWS100AE; otherwise, the
LWS100A/LWS100AE may be damaged.
2.8 Install SerialComm™ Utility
Please follow the steps below to install SerialComm™ utility into the PC/NB. This utility support several
functions: Virtual Com, Auto Discovery, directly connect with discovered IP devices, LED status graphic display
and Ping IP connectivity.
1) Insert the supplied CD-ROM in the CD-ROM driver.
2) After inserting the CD-ROM into the driver, the SerialComm™ utility will be automatically executed.
Follow the prompt instructions to finish the installation.
3) Or, directly execute the file
Setup.exe in the CD-ROM.
2.9 Initial Settings
For setting up your LWS100A/LWS100AE at the first time, the first thing you should do is to configure the IP
address, SSID and WEP settings. The PC/NB, AP and LWS100A/LWS100AE should be within at the same IP
subnet. AP and LWS100A/LWS100AE should have same SSID and WEP settings.
The default IP address, SSID and WEP of the LWS100A/LWS100AE is set to:
IP address: 192.168.1.200
SSID: WLAN
WEP: Disable
Select one of the following methods for your LWS100A/LWS100AE initial setting.