LWS100A/LWS100AE User’s Manual
16
2.9.2
Change LWS100A/LWS100AE Settings
Your PC/NB needs to be connected with LWS100A/LWS100AE serial port. Follow the steps below to configure
LWS100A/LWS100AE:
Set LWS100A/LWS100AE serial port to be the console port as described in section 2.4. The
permanent, default settings for console port are:
Baud Rate:
2,400
Data Length:
8
Parity:
None
Stop Bit:
1
Flow Control:
None
Follow the steps described in section 4.1 and 4.2 to set the PC/NB COM port and open Microsoft
HyperTerminal.
Use the commands described in section 4.3 and 4.4 to change LWS100A/LWS100AE IP address.
LWS100A/LWS100AE IP address should have same IP subnet as your PC/NB and AP have.
The commands are:
IP <IP_Address>
MASK <IP_Address>
GW <IP_Address>
Use the commands described in section 4.3 and 4.4 to change LWS100A/LWS100AE WLAN
Operation Mode, Channel, SSID and WEP settings. They also should be the same as your AP has.
The commands are:
MODE <[B]SS|[A]d-Hoc>
Note: “B” for infrastructure and “A” for Ad-Hoc mode
SSID <SSID>
CHAN <1-11>
Note: Only needed for Ad-Hoc mode
.
WEP <0|64|128>
Note: When “0” is set, WK and WKID is not needed
.
Format <1|2>
Note:
1
for ASCII char and
2
for HEX char
WK <0|64|128> <1-4> <Key in Hex>
WKID <1-4>
Summary of Contents for LWS100AE
