48
-
This may be that the set voltage and/or frequency is outside of the set limits in the menu
settings. Refer to the voltage limits section under “
Voltage Limits
” or frequency limits
under “
Frequency Limits
” to verify and configure these limits.
Q: Why does my output waveform look cut off and distorted on my oscilloscope?
-
Check to see if the dimmer function is enabled. If it is, it is likely the result of the phase
being cut, which results in a distorted waveform. This also leads to less RMS voltage. See
the
Dimmer Output Simulation
section for more information.
Remote Control
Q: I am trying to send the commands over USB/RS232, but it does not seem to respond.
-
Check that you are sending ASCII strings that are terminated with a CR (carriage return)
and LF (linefeed) character.
-
For RS-232, check that the baud rate, parity, data bits, stop bit, and flow control settings
match with the settings configured on the software interface.
-
Check that pins 2 and 3 are not crossed.
