11
hole on the fastener of corrugated item, then to the holes in the screw
heads (located on the diagonal) and through the second hole on the
fastener of the corrugated item. Extend both ends of the wire through
reach-through holes, turn the seal clockwise against stop. Break off the
tail piece used for the sealing.Cut the excess wire with the tool.
To seal the connecting group, extend the wire through the sealing
holes of the corrugated holder on both sides of the connection (from the
side of the fuel gauge and from the cable connected to the tracker). Then
perform seal tightening up on the wire.
Do not forget to record the serial numbers of the seals specified on
the front side.
CONNECTION TO TRACKER
The fuel gauge equipment includes a connection cable for the data
reading device, one side of the cable contains is a connector (to connect
directly to fuel gauge BI FLSensor itself), on the other side it contains the
cut end with 5 wires, which is connected to a data reading and
processing device. Purpose of conductors is specified in Table 4.1.
Table 4.1. Purpose of conductors
BI FLSensor
Connected equipment
No.
Wire
colour
Purpose
BI910/BI920
BI810/BI820
1
Yellow
A
Green/Red
B7
Orange
А
2
Green
B
Green/Black
C7
Green
B
3
Brown
Signal
GND
Black
С1/С8
Black
GND
4
White
+VCC
Yellow
B8
Yellow
+Vout
5
Grey
Power
GND
Black
С1/С8
Black
GND
6
Not
applied
-
-
-
-
-
Different issues can be solved depending on organization of the fuel
gauge connection to the in vehicle network and GPS-tracker.
The diagrams below contain the circuit examples:
(1)
before the battery disconnect switch
(2)
after the battery disconnect switch
