SignalHawk™ PC and Rack Mount Models
39
Preamp
Controls the built-in amplifier on the signal input. This lowers the noise floor,
allowing very low power signals be detected, by giving a 24 dB nominal gain
boost.
Note:
Attenuation is automatically disabled to 0 when Preamp is
activated.
Note:
The preamp should not be used with input signals greater
than -30 dBm.
Offset
Shifts the signal to compensate for external factors (attenuation, couplers,
amplifiers, etc.) This allows for a true signal level reading.
1.
Measure the total amount of loss for all attached signal devices.
2.
Enter the measured amount as the Offset value or gain.
Example -
The system has 10 dB of loss due the use of a coupler;
enter the value of 10 in the Offset. Offset range is -100 to +100.
Units
dBm
dBm
10
Log Power Watts
30
dB
+
=
dBuV
dBm
dBuV
10
50
log
90
–
–
=
dBmV
dBm
dBmV
10
50
log
30
–
–
=
dBV
dBm
dBV
10
50
log
30
+
–
=
Volts
dBm
20
Log Power Volts
=
30
dB
+
Watts
Watts
10
dBm
30
–
10
=
Trace
Opens a trace submenu with the following options:
Clear Write
Switches off the Average and Max Hold functions.
Max Hold
Holds and displays the highest point of a any given sweep until Max Hold is
turned off.
Summary of Contents for SignalHawk SH-36S-PC
