BCP-760
Operation Guide
Page 14 of 31
Setup up-case and low-case Alpha character input
User can define upper-case or lower-case input on Alpha mode.
3.1.6
Supervisor Mode
The BCP-760 Supervisor mode allows the user to configure and validate the BCP-760 hardware. To switch
the BCP-760 to the Supervisor mode of operation do the following:
1. Turn off the BCP-760.
2. Press and hold down the [CMD] and [
] keys simultaneously, then switch on the BCP-760 by pressing
the [
⊙
] key. The BCP-760 LCD first shows the ‘START MENU” where the user has three (3) choices:
1.Enter the Supervisor mode, 2.Command the BCP-760 to execute a Warm Start, 3. Command the
BCP-760 to execute a Cold Start.
After selecting 1, a
password entry is requested from the user to prevent unauthorized users from accidentally
changing configuration parameters. The system will return to the Ready mode after 5 unsuccessful tries. The
default password is “760”. The Supervisor mode menu will be shown on LCD after the correct password is
keyed-in.
The Supervisor Mode function lets the user set the following functions:
1. DEV:
Device Configuration
2. TERM:
Terminal Configuration
3. MEM:
Memory Configuration
4. FORM:
FormBuilder Define
5. PWR:
Set Resume/Auto-Off/Alarm of program
6. PSWD:
Password Change
7. SYS:
System Initialization, update BIOS
8. DIAG:
System Diagnostic
1.8.1.9
Device Configuration
When selecting the option "1.DEVICE", the LCD will offer the user 3 choices: 1)
Set the keypad input Language setting, 2) Set the serial port communication
parameters, and 3) Enable/disable supported bar code symbologies.
1.KEYPAD
The BCP-760 supports several international language setting. The default language setting is
ENGLISH. Press [
] or [
] to select different language setting. There are Sweden/Finland,
Danish, Spanish, French, German, and Italian. Press [ENT] to confirm the setting and return to
the previous menu.
2.SERIAL
The BCP-760 supports one RS232 port on flat 12 pin connector. Data can be downloaded to
and uploaded from the BCP-760 via the serial data communication port. The communication
parameters must be set correctly in order to send/receive data via the RS232 port. Default
setting for the serial port is 19200 bps,8 data bits, No parity, One stop bit
<DEVICE CONFIG>
1.KEYPAD
2.SERIAL
3.BARCODE
<START MENU>
1.SUPERVISOR
2.WARM START
3.COLD START
SUPERVISOR
MODE
PASSWORD:
1.DEV
2.TERM
3.MEM
4.FORM
5.PWR
6.PSWD
7.INI
8.DIAG