BCP-760
Operation Guide
Page 16 of 31
EAN/UPC ADD-ON
Disable/Optional/Required (DISABLE)
Send/No-send Check Digit (SEND)
Code 128
Enable/disable decoding (ON)
EAN 128
Enable/disable decoding (ON)
Code 93
Enable/disable decoding (ON)
Code 32
Enable/disable decoding (ON)
User code 1
Enable/disable decoding (OFF)
User code 2
Enable/disable decoding (OFF)
1.8.1.10
ASCII Terminal Configuration
The TERM command enables the BCP-760 to run a built-in Terminal emulator. The BCP-760 will operate as
a dumb ASCII terminal when the user select this feature and disable the FormBuilder menu.
When the TERM SETUP menu (shown below) appears on the BCP-760 LCD, proceed to set up the portable
terminal communication parameters. When finished go to the User Mode menu and press 2 (2.TERM) to
make the BCP-760 operate as a dumb ASCII terminal.
Terminal ID Each BCP-760 "Terminal" can be identified by an 8-character string
Terminal ID assigned by the user. Initially, the default ID is
"BCP760". Valid characters for assigning Terminal ID are
alphanumeric characters ('A'-'Z', '0'-'9'). Hit [ENT] to make the
selection.
Online
Use the [
] key to toggle between REMOTE and LOCAL,
then hit [ENT] to make the selection.
REMOTE The BCP-760 will output data gathered from the
bar code port or keypad to its RS-232 port.
LOCAL
The BCP-760 does not transmit gathered data to its RS232 port.
Echo
Use the [
] key to toggle between ON and OFF, then hit [ENT] to make the selection. The
collected data will be displayed on the BCP-760 LCD when Echo is set to ON, otherwise data
will not be displayed when it is set to OFF.
AutoLF
Use the [
] key to toggle between ON or OFF, then hit [ENT] to make the selection. When
AutoLF is set to ON, the BCP-760 will append a LF (10 hex) character to the input data block.
Mode
Use the [
] key to toggle between BLOCK and CHAR, then hit [ENT] to make the selection.
See section 3.2.2 for the description of Block and Character modes.
Line/Page
Use the [
] key to toggle among LINE, PAGE and BOTH, then hit [ENT] to make the
selection.
<<TERM SETUP>>
TERM ID.
BCP760
<<TERM SETUP>>
ONLINE
REMOTE
<START MENU>
1.SUPERVISOR
2.WARM START
3.COLD START
SUPERVISOR
MODE
PASSWORD:
1.DEV
2.TERM
3.MEM
4.FORM
5.PWR
6.PSWD
7.INI
8.DIAG
<TERM SETUP>
TERM I.D.
BCP710