OPA2-VC Operation Terminal
Technical Data
Doc: 70-00-0196A, V1.3, 20220222
© Vector Controls GmbH, Switzerland
Page 1-4
Subject to alterations
www.vectorcontrols.com
OPA2-VC
Communicating Operation terminal
Features
•
Display and change of operation state and set points
•
Display input values according to real values not voltage signals
•
Display and change of configuration parameters
•
Integrated temperature sensor (-T)
•
Surface mounting
Applications
•
Configuration and operation of TCX2 controllers
•
Remote supervision (RS485)
General Description
The OPA2-VC is a remote display and operation terminal for TCX2 series controllers.
Ordering
Item Name
Item Code
Passive inputs
Humidity sensor
Description/Option
OPA2-VC
40-50 0007
Operation terminal for TCX2 controller
with internal temperature sensor
Mounting location
•
Install the operation terminal on an easy accessible interior wall, approx. 1.5 m above the floor in an area of average
temperature.
•
Avoid direct sunlight or other heat sources, e.g. the area above radiators and heat emitting equipment.
•
Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
•
Location of mounting is less critical if external temperature sensors are used.
Installation
See installation sheet no. 70-000113C (www.vectorcontrols.com).
Dimensions
Important notice and safety advice
This device is for use as operating controls. It is not a safety device! Where a device failure endangers human life and/or
property, it is the responsibility of the client, installer and system designer to add additional safety devices to prevent a
system failure caused by such a device failure. Ignoring specifications and local regulations may cause equipment damage
and endangers life and property. Tampering with the device and misapplication will void warranty.
88 (3.5)
88
(
3.
5)
21
(0.8)
9
(0.3)
