www.biopac.com
BIOPAC Hardware |
Nerve Chambers
| Page 2 - 2
Updated: 3.27.2013
NERVE CHAMBER CONNECTIONS
To connect the Nerve Chamber to MP-series Biopotential amplifiers
(MCE100C, ERS100C, or EMG100C),
use three JUMP100 connectors and three CBL200 adapter cables. Optionally, for additional lead length, use one
MEC110C extension cable.
1.
Plug the three JUMP100s into the desired points of the Nerve Chamber.
2.
Connect the free ends of the JUMP100s to the mating ends of the CBL200s.
3.
Then connect the free ends of the CBL200s to the Biopotential amplifier inputs. For additional lead
length, plug the MEC110C into the Biopotential amplifier and plug the free ends of the CBL200s into the
free end of the MEC110C.
To connect the Nerve Chamber to the STM100C Stimulator
, use one CBL106 and one CBL102.
1.
Plug the red and black leads (2mm pins) of the CBL106 into the desired points of the Nerve Chamber.
2.
Connect the free end (Female BNC) of the CBL106 to the mating end (Male BNC) of the CBL102.
3.
Then insert the free end of the CBL102 (3.5mm phone plug) into the 50 Ohm output of the STM100C.
Note:
If the STM100C Stimulator is used with a Biopotential amplifier on the same nerve—which is nearly
always the case—make sure that the black lead of the CBL106 (stimulation negative) is connected to the
same pin as the ground lead going to the Biopotential amplifier. This is easy to do because the design of
the JUMP100 allows stacking connections.
HARDWARE GUIDE