WR1500N
150Mbps Wireless N Router
Figure 2-1 Hardware Installation of the WR1500N 150Mbps Wireless N Router
2.3.1 Repeater Mode
After finishing the steps above, please choose the operation mode you need and carry out the
corresponding steps.
WR1500N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of WR1500N should be the same as that of the device you repeat.
To avoid the conflict of DHCP service with front-end devices, the DHCP server is default to be
closed on this mode. If you want to log in the management page, please set your computer’s IP
address manually.
1. Plug the power plug of WR1500N in electrical wall socket.
2. Power on the notebook(s).
Note:
It is recommended that you connect a PC/notebook to the LAN port of the Router with an Ethernet
cable, and then login the Router from the PC/notebook to set the Router in AP Repeater mode.
- 6 -
