9
Device Description
The Front LEDs
LED
Meaning
1
Internet
Lit red when WAN port fails to get IP address.
Lit green when WAN port gets IP address successfully.
Lit off when the device is in bridge mode or when ADSL connection
is absent.
2
DSL
Lit green when the device is successfully connected to an ADSL
DSLAM. (“line sync”)
3
3G
Lit green when 3G service is ready.
Blinking orange slowly when 3G signal is weak; blinking orange fast
when 3G signal is middle; lit
up orange steady wh
en 3G signal is
strong.
Lit off when there is no 3G signal.
4
Wireless / WPS
Lit green when a wireless connection is established.
Flash orange when WPS configuration is in progress. However, if
WPS fails the LED will only lit for 1 min before goes off.
Blinking when data is transmitted/received.
5
Ethernet port
1X - 4X
(RJ-45 connector)
Lit green when successfully connected to an Ethernet device.
Blinking when data is transmitted/received.
6
Power
When the device is booting, the green light will lit while the red light
will flash.
When the system is ready, it will lit green.
Lit red when the device fails to boot or when the device is in
emergency mode.
Summary of Contents for BiPAC 7800GZ
