84
file via console port.
3
The default username is “admin”. The default password is “admin”. The
Password
and
Username
fields are case-sensitive. Make sure that you enter the correct password and
username using the proper casing.
4
It is highly recommended to change the default username and password. Make sure
you store the username and password in a save place.
A.6 LAN Interface
I cannot access the BIPAC-5100/5100W from the LAN or ping any computer on the LAN.
STEPS
CORRECTIVE ACTION
1
Check the Ethernet LEDs on the front panel. A LAN LED should be on if the port is
connected to a computer or hub. If the 10M/100M LEDs on the front panel are both off,
refer to
Section A.1.2
.
2
Make sure that the IP address and the subnet mask of the BIPAC-5100/5100W and
your computer(s) are on the same subnet.
A.7 WAN Interface
Initialization of the ADSL connection failed.
STEPS
CORRECTIVE ACTION
1
Check the cable connections between the ADSL port and the wall jack. The DSL LED
on the front panel of the BIPAC-5100/5100W should be on.
2
Check that your VPI, VCI, type of encapsulation and type of multiplexing settings are the
same as what you collected from your telephone company and ISP.
3
Restart the BIPAC-5100/5100W. If you still have problems, you may need to verify your
VPI, VCI, type of encapsulation and type of multiplexing settings with the telephone
company and ISP.
I cannot get a WAN IP address from the ISP.
STEPS
CORRECTIVE ACTION
1
The ISP provides the WAN IP address after authenticating you. Authentication may be
through the user name and password, the MAC address or the host name.
2
The username and password apply to PPPoE and PPoA encapsulation only. Make sure
that you have entered the correct
Service Type
,
User Name
and
Password
(be sure to
use the correct casing).
