14
2.5.1 Using The Reset Button
Step 1.
Make sure the SYS LED is on (not blinking).
Step 2.
Press the RESET button for five seconds, and then release it. When the SYS LED
begins to blink, the defaults have been restored and the BIPAC-5100/5100W restarts.
2.5.2 Uploading a Configuration File Via Console Port
Download the default configuration file from the Billion FTP site, unzip it and save it in a folder.
Step 1.
Turn off the BIPAC-5100/5100W, begin a terminal emulation software session and
turn on the BIPAC-5100/5100W again. When you see the message "Press Any key to
enter Debug Mode within 3 seconds", press any key to enter debug mode.
Step 2.
Enter "atlc" after "Enter Debug Mode" message.
Step 3.
Wait for "Starting XMODEM upload" message before activating Xmodem upload on
your terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 4.
Click Transfer, then Send File to display the following screen.
Step 5.
After successful firmware upload, enter "atgo" to restart the router.