Bike-Lift TWIN-ARMS MTA 516, Use And Maintenance Manual

Page: 33 / 39

Operating manual No. 057-2-6-0013-R0
Version
2018
Page 34
EN
8.5.2 ELECTRIC PUMP
INCONVENIENT
AND
PROBABLE CAUSE REMEDY
The lifting
platform during
the ascent and/or
descent vibrates
excessively
or
Air presence in the
Hydraulic
circuit
It is necessary to bleed the hydraulic
circuit by lifting and lowering the lifting
platform a few times.
The lift climbs
slowly and with
difficulty
Oil too viscous
If the air temperature falls below -6°/-
10° C, the oil decreases its fluidity. To
solve this problem, lift and lower the lift
a few times so that the oil increases its
temperature.
Operating on the
button panel, the
motor runs but
the lift does not
rise. Oil level in the pump too
low.
Remove the casing of the pump and check
the oil level through the plug
(Figure 12). If
the level is too low, add ISO VG 10
hydraulic oil.
Hydraulic pump problems Contact the dealer or Bike-Lift Europe s.r.l
Operating on the
button panel the
motor does not
run
The emergency stop (red
button in case of the built-
in lifting platform version)
on the button panel is
inserted
Release the red button on the button
panel by turning it clockwise.
No voltage
Check the mains connection plug
Improper operation of the
button unit on the button
panel
Replace the button unit
The motor is short-circuited
Contact the dealer or Bike-Lift Europe s.r.l