Operating manual No.
057-2-6-0013-R0
Version
2018
Page 25
EN
7.1.3
Operation with both wheels lifted
8-
Slide the belt joint along the guide until it reaches the rear wheel;
9-
Pass the belt through the rear wheel and secure the wheel, leaving it free to lift;
10-
Proceed with the lifting control of the component arms until both wheels reach
the desired height
7.2
Unloading operations
1-
Make sure that the sliding guides of the MTA 516 lift are free from foreign bodies (bolts
or other objects would stop the descent and could cause serious damage or dangerous
jolts);
2-
Completely lower the additional component and bring both wheels back on the
platform;
3-
Position the wheel clamp in front of the front wheel and fix the structure on the
platform using the appropriate hooks;
4-
(unhook any belts that have been used to secure the motorcycle); 5- Push the
motorcycle until the front wheel goes into the vise; 6- Reassemble the ascent ramp;
7-
Make sure that the scissor sliding guides are free from foreign bodies (bolts or other
objects would stop the descent and could cause serious damage or dangerous jolts);
8-
Move the flow deviation lever at the base of the lifting platform to use the same control
also for the scissor lifting platform;
9-
Use the pump to raise the lifting platform with about 3 cm then release the safety bar
(Figure 5, [5]) through the special lever placed sideways. Operate the descent control;
10-
Once the descent is complete, open the locking vise of the front wheel and lower
the motorcycle using the brakes to stop the stroke
Summary of Contents for TWIN-ARMS MTA 516
Page 36: ...Operating manual No 057 2 6 0013 R0 Version 2018 Page 37 EN SPARE PARTS TECHNICAL DRAWINGS ...
Page 37: ...Operating manual No 057 2 6 0013 R0 Version 2018 Page 39 EN ...
Page 38: ...Operating manual No 057 2 6 0013 R0 Version 2018 Page 39 EN NOTES ...
Page 39: ...Operating manual No 057 2 6 0013 R0 Version 2018 Page 39 EN NOTES ...
