Bike-Lift TWIN-ARMS MTA 516, Use And Maintenance Manual

Page: 12 / 39

Operating manual No. 057-2-6-0013-R0
Version 2021
Page 13
EN
-
2.4 Intended use
Disseminate the instructions described in this chapter to all personnel involved
in the preparation and use of the machine.
The machine is designed for additional lifting of motorcycles for maintenance purposes.
The machine has been designed and built for the specified use; a different use and
non-compliance with the technical parameters set by the Manufacturer may be
dangerous for the operators.
It can be used in the mechanical motorcycles repair shops both for the mechanical part and
for the bodywork.
The Operator must always work in proper lighting conditions and wear clothes and
protections appropriate to the task performed (typical activity of mechanical workshop)
The working position of the operator during the ascent and descent phases is in the area
around the machine at the safety distance allowed by the cable length of the control panel.
It is absolutely forbidden to lift motorcycles while leaning on the side
kickstand
Do not try to lift motor vehicles weighing more than the maximum capacity
of the platform.
Do not try to lift four-wheeled vehicles, using two lifting platforms placed
side by side.
Do not stand under the suspended motorcycle.
Any other use different from the one indicated is to be considered as not
planned and may cause damage to the machine and Operators. It is therefore
FORBIDDEN .
The machine must always be operated by only one Operator.