Bike-Lift TWIN-ARMS MTA 516, Use And Maintenance Manual

Page: 18 / 39

Operating manual No. 057-2-6-0013-R0
Version 2018
Page 19
EN
The cardboard and wooden packaging must be lifted using a forklift truck, by inserting the
forks inside the wooden supports.
During the unloading phase, in any case, pay attention to the vehicles and people in transit.
Make sure there are not many holes in the floor or on the high slope ramps for the vehicle
used, in relation to the load carried; always proceed at low speed with the means of transport.
The unloading from the wooden pallet of the cardboard packaging containing the lifting bench,
carried out manually by no less than four Operators equipped with workshop gloves, must be
done near the location where the machine will be installed.
4.4 Receipt and check
The packaging is made of suitable material and is carried out by expert personnel, but during
the journey it is possible to be deteriorated or damaged.
Upon receipt of the machine, immediately check if the packages are clearly damaged.
If so,
accept the goods with reserve, by making photographic evidence of any damage.
Open the box by cutting the clips and the closing adhesive tape.
Make sure all the material shown on the delivery note is actually present.
Make sure the parts of the machine have not been damaged during transport and notify any
damage within 5 days of receipt. Carrier by REGISTERED LETTER (and notify Bike Lift Europe
s.r.l.), by presenting photographically documented evidence.
4.5 Storage
Pending to be unpacked and installed, the machine must be stored in a suitable environment
in order not to alter its operation.

Store the packed machine in a closed or covered area above the ground by using
sleepers or similar objects.

Room temperature and humidity: -5°/75 ° C Relative humidity between 30% and 90%.

Do not overturn the packaging.

If the machine is stored without packaging, it must be positioned firmly on wooden
sleepers and covered with a cloth.

Do not stack anything on the machine.
It is recommended that the unloading or handling operations to be carried out
with a forklift truck by a single Operator equipped with workshop gloves, safety
footwear and protective helmet, as required by current regulations.
This Operator must pay maximum attention to all transport phases.
Do not allow any other person to stand in the operation area of the forklift truck
in order to prevent the accidental fall of the boxes from being dangerous.