5.0
Operation
5.1
Attachment to the Tractor
Drawbar
Requirements
The drawbar is normally supplied with a ring hitch, which is
suitable for connection to the pickup hitch found on most
tractors in the UK.
Ensure that your tractor hitch is suitable for this type and
dimension of ring.
Ensure the capacity is a minimum of 3 Tonnes. Additionally,
the recommended minimum horsepower is 140 HP and 6
Tonnes weight.
An oil supply of at least 60 L/min @ 200 bar (8.79
Gallons/min (UK) @ 2900 psi) and a minimum electric
supply of 20 Amps @ 12v DC are required. The tractor must
be fitted with a power beyond unit.
Attaching
Hitch the tractor to the machine. Remove and store the
drawbar stand and pin. The machine should now sit
approximately level at the chassis.
Turn the tractor cautiously and ensure the tractor links etc
do not foul on any part of the machine and that there is
sufficient clearance for hoses etc. Remove links if
necessary.
Connect the brakes to the tractor and ensure correct
operation.
Release the hand brake
(Fig. 7)
, which is under the front
left of the chassis, and obtain assistance to check the
operation of the trailer brake cylinders when the brake pedal
is depressed.
Ensure the tractor lighting voltage is 12 v DC before
connecting the lights.
Connect the lights via the 7-pin plug stored just off centre of
the service post and confirm correct operation.
Tractor connections and identification colours are as follows;
(Fig. 8)
Hose 2 – Pressure – Red - 3/4” Hose
Hose 3 – Return – Blue – 1” Hose
Hose 4 – Load Sense – Yellow – 1/4” Hose
Hose 5 – Pilot drain – Blue- 1/4” Hose
For tractors with only three connections available hoses 3 &
5 may be joined together using a tee piece at the tractor
end.
Please ensure that the above connections to the tractor’s
power beyond unit are made in accordance with your
Tractor Manufacturers instructions and Guidelines.
9
Fig. 7
Tank
Blue
No. 5
1/4” Hose
No. 3
1” Hose
No. 1
3/4” Hose
No. 4
1/4” Hose
Tank
Pressure
Load Sense
Blue
Red
Yellow
No. 2 3/4” Hose
F1
10
Micron
Fig. 8
WARNING:
Oil under pressure can penetrate skin. Seek
medical advice involving any incident where this may occur.
Oil is an irritant. Wear protective gloves when handling.
CAUTION:
Ensure the tractor will supply at least 60 L/min
@ 200 bar (8.79 Gallons/min (UK) @ 2900 psi and does not
exceed 80 L/min (17.6 Gallons/min (UK)).
Set the flow at 40-50 L/min. (8.79 - 11.0 Gallons/min (UK)).
5.2
Hydraulics
Summary of Contents for Transtacker Extra
Page 2: ...2 ...
Page 34: ...10 0 Electrical Hydraulic Systems 34 Fig 92 10 2 Hydraulic Diagram ...
Page 35: ......