BIG BALE Transtacker Extra, Operation And Maintenance Manual

Page: 19 / 36

5.0 Operation
5.13 Finishing a Stack
When the platform is full a sensor on the rear of the
platform will signal and illuminate the LCD.
The stacking cycle will stop and the rear clamp will
automatically clamp the bales (Fig. 49) . This will be
indicated by a flashing ‘
FULL
’, followed by a constant
‘ FULL ’, when the bales are clamped.
1. If the table has returned to bottom stops, proceed to
pickup bales. Ensure more bales will clear the bales already
in the platform.
2. If the table has not descended then hold down the middle
button and push the joystick forward (Fig. 50). If the table
descends, more bales can be loaded. If it does not then the
machine is full and the completed tower must be erected
before more bales can be loaded
(Fig. 51)
.
19
Fig. 49
Fig. 50
5.12
The stacking cycle is complete.
To manually tie a layer Cont.
8. Hold down the middle button and move the joystick left
(Fig. 46) to lower the table away from the bales to a point
not fully lowered.
9. Hold down the top right button and move the joystick right
(Fig. 47)
until the table is straight.
CAUTION:
The table must not be rotated in its
fully lowered position or damage may occur.
10. Hold down the middle button and move the joystick left
(Fig. 48)
to return the table to its bottom stops.
Fig. 46
Fig. 47
Fig. 48
Fig. 51
Operation