7.0
Trouble Shooting
30
Symptom
Cause
1.
The pickup tines enter the bale and immediately
Pickup up (1) sensor has failed to always closed.
withdraw.
Try unplugging the sensor.
2.
The pickup lifts the bale to the hold position and stops.
Table lift down (7) sensor has failed to always open.
Check the adjustment of the sensor.
3.
The pickup lifts the bale to the top and stops.
Pickup up (1) sensor has failed to always open.
Check the adjustment of the sensor.
4.
The pickup lifts the bale to the top, the tines retract
Pickup down (2) sensor has failed to always closed.
but the pickup stays in a high position.
Try disconnecting the sensor.
5.
The pickup returns to the down position but fails
Pickup down (2) sensor has failed to always open.
to stop the cycle and the hydraulic pressure.
Check the adjustment.
6.
The stack cycle will not start but the hydraulic system
Table lift down (7) sensor has failed to always open.
pressurises. Check
adjustment.
7.
The stack cycle fails to tie the bales.
Tied (8) sensor has failed to always closed.
Try disconnecting the sensor and continue with #.
8.
The table lifts fully but fails to push back.
Extension in (4) sensor has failed to always closed.
Try disconnecting the sensor.
9.
The table pushes back but stops with the hooks in
Extension in (4) sensor has failed to always open.
the bale.
Check adjustment/operation of the sensor.
10.
The table starts to return to its level position but stops half
Tie return (9) sensor has failed to always open.
way down.
Check adjustment.
11.
The table returns fully down but has not returned to the
Tie return (9) sensor has failed to always closed.
correct rotational position.
Try disconnecting the sensor and continue with #.
12.
The table returns fully down but the cycle does not stop
Table lift down (7) sensor has failed to always open.
and the hydraulics remain pressurised.
Check the adjustment of the sensor.
13.
Auto clamp fails to operate.
Guide in (10) sensor has failed to always open.
Check adjustment. (The guide must be out).
14.
Auto clamp operates before the platform is full.
Full platform (11) sensor has failed to always closed.
Check operation. Try disconnecting the sensor.
15.
Auto clamp works when tipping off or loading a stack.
Guide in (10) sensor has failed to always open.
(The guide must be in).
16.
Platform does not raise.
Forks not in home position.
Fig. 89
Summary of Contents for Transtacker Extra
Page 2: ...2 ...
Page 34: ...10 0 Electrical Hydraulic Systems 34 Fig 92 10 2 Hydraulic Diagram ...
Page 35: ......
