Instructions for use - BW 585
BIEGLER
7 MANUFACTURER LIABILITY
The manufacturer and the supplier of the device reject all liability if:
•
the device is not used in accordance with the instructions for use
•
the operating personnel are inadequately qualified or are not sufficiently
informed about the functioning of the device on the basis of the instructions
for use and the safety instructions
•
repairs are not performed exclusively by the manufacturer or by persons and
service centres expressly authorised by manufacturer
•
the device is used in places in which the electrical installations do not comply
with the applicable national standards, or if power supply during the period of
use of the device is not guaranteed
•
original spare parts material are not used or the maintenance interval is not
complied with.
Disposal of the device and its accessories is carried out in accordance with the
applicable local regulations.
8 WARRANTY CONDITIONS
The manufacturer guarantees that all flaws of material and workmanship which
arise within 24 months from date of purchase will be repaired free of charge.
Claims are only accepted under the following terms:
•
The manufacturer and/or supplier is informed immediately of the fault for
which the warranty claim is being made.
•
The instructions of the manufacturer and/or supplier on storage or return of
the device are complied with.
•
Presentation of a legible copy of the invoice for the device concerned,
showing the date of purchase
.
•
An exact description of the defects or malfunctions identified by the customer.
The manufacturer's warranty will be void if it is found that the maintenance,
disinfection and inspection instructions have not been followed according to the
instructions for use, the device was damaged by force or operating error, or was
used in any way contrary to the instructions for use and safety instructions. The
warranty will also be void if not original Biegler materials were used as
replacement parts, or measures for repair were undertaken by persons not
authorised by the manufacturer or supplier.
10
EN - Edition 03 / 2007
BIEGLER
Instructions for use - BW 585
Switch the device into Standby mode using control
(Diag.1/3).
Release pressure from the system by switching off any pressure cuffs or
infusion pumps used. Empty and disconnect the system as far as possible.
Remove the consumable material from the heat exchanger (Diag.1/1) and
dispose of it according to the relevant regulations.
Disconnect the device from the power supply and clean and sterilize as in
section „cleaning and disinfection“ of these instructions.
4 MAINTAINANCE
The BW 585 is designed as a low-maintenance device. To preserve the quality
and functional safety, please comply with the following points:
•
Always keep the device and its accessories clean (see section: cleaning and
disinfection).
•
The periodic technical safety inspections must be carried out (see section:
periodic inspections)
5 CLEANING AND DISINFECTION
The device may only be cleaned using a soft cloth with water-soluble, non-
aggressive cleaning agent or a special cleaning agent for plastics.
For the purposes of disinfection, ready-made alcohol-based spray disinfectants
can be used.
Important: Before cleaning or disinfection, the device must always be
disconnected from the mains power supply.
EN - Edition 03 / 2007
7
