EN
8
Operating Notes
•
If you want to prepare sauces, soups or nut milk, add the ingredients in 2 to 3 steps, depending on their hardness. The
amount should not be too little, but also not too much. Too many ingredients in one process can lead to overheating and
automatic shutdown of the motor. Wait in that case until the device cools off as described above (see page 5).
•
Always keep the lid closed during the operation of your
Panda
. This avoids any scalding or splashes of hot foods.
•
Never put your hands into the mixing container during operation to avoid injuries.
•
Do not dip any objects into the mixing container during operation, since otherwise the motor, blades and other parts
of the device can be destroyed. Except for the supplied tamper that may only be used through the lid opening (Fig. [2],
page 1), since it cannot contact the blades through the opening for the measuring beaker. On page 17, you will find the
description of the tamper.
•
When preparing hot drinks, soy milk or warm soups, make especially sure that the lid is closed well and your
Panda
is
standing securely. It is advisable to first with start at low speed and then to increase it gradually. Alternatively you can
either use the Pulse mode or one of the preset programs (warm soup, see page 14).
•
Always pour liquids and soft ingredients first into the mixing container and afterwards the harder ingredients, such as
ice cubes, green leaves etc.
•
If the chosen program or the manual mode is finished, please wait until the blades are fully stopped before removal of
the mixing container. Otherwise the connection can be damaged.
•
Overloading the mix container may cause an intensive odor. Reduce the ingredients and proceed with the preparation.
•
If a singed smell exudes from the motor block, stop the device immediately and disconnect the power supply. The smell
can result from abrasion of the rubber bearing of the connection if it was not mounted correctly. In this case, please
contact your bianco di puro customer service immediately.
•
When preparing thick and sticky ingredients such as dough, it can happen that the motor and the blades turn idly, this is
because an air bubble has formed in the ingredients, stop the programme and remove only the measuring beaker. Your
can remove the air bubble through the opening with the included tamper. Replace the measuring beaker and continue
the preparation.
