BETCO CCRRSS2288, Operator'S Manual

Page: 79 / 91

rc2202rev06-gb Data 12/00 - GG Rev. 06 03/03 - MZ Page 10 of 15
11. It appears the request for confirmation of the new values – press
ENTER for confirmation.
ARE YOU SURE?
VERIFY THE LOADED DATES: LIFT AT LEAST ON TRACTION WHEEL
1. Move in the list with the buttons ROLL UP or ROLL DOWN from
"PROGRAM VACC" to the menu "TESTER".
* SELECT MENU *
2 TESTER
2. Press ENTER.
3. Select with ROLL: “ MOTOR VOLTAGE ”.
MOTOR VOLTAGE
VOLT = 00,0
4. Try to insert the forward and reverse gear. The initial voltage should
be between 0 V and 1 V
5. Press with the forward gear until the end and verify if you achieve
the max. voltage of the battery. With ROLL move to “VOLT
BATTERY”. The two values should have only some tenth of
difference.
6. Note: The reverse gear is reduced about 30% in comparison to the
forward gear for the safety of the operator.
7. Press OUT and return to the initial description, switch off the general
key and remove the console connection from the chopper.
MX v.2.1
HOURS 0
8. AFTER THE CONTROLS LET THE TRACTION WHEEL DOWN ON
THE FLOOR.
MX v.2.1
HOURS 0