BETCO CCRRSS2288, Operator'S Manual

Page: 11 / 91

39
MACHINE PREPARATION
8 . S Q UEEGEE ASSEMBLY
T he squee g ee, which is packed separately f rom the machine, should be assembled as
shown in the f i g ure . I nsert f irst the le f t squee g ee pin (1) in the le f t arm slot, then the
ri g ht pin (2) into the ri g ht slot, payin g attention to keep the sprin g and the washer over
the blade o f the arm itsel f. T o simpli f y this operation the handwheel placed on top o f the
pin should be loosened previously . Af terwards, lock the handwheel to block the
squee g ee in position .
F it the squee g ee hose into its couplin g (3)
2
3
1
9 . S Q UEEGEE INCLINATION
D urin g workin g operation, the rear rubber has to work sli g htly tilted backwards and this
equally in its whole len g th f or about 5 mm .
T his allows the squee g ee rubber to be used f our times be f ore it has to be replaced .
If it is necessary to increase the rubber bendin g in the central part, tilt the squee g ee
body backwards and turn the adjuster (1) counterclockwise . If the rubber bendin g is to
be noticeable at the sides o f the squee g ee, turn the adjuster (1) clockwise .
10 . AD J USTMENT HEIGHT S Q UEEGEE SUPPORT
T he squee g ee has to be re g ulated dependin g on the wearin g o f the rubbers . T o adjust
this, rotate the knob (2) clockwise (ti g hten) to li f t the squee g ee and counterclockwise
(loosen) to lower it .
N ote: T he ri g ht and le f t wheels must be re g ulated in the same amount so that the
squee g ee works in parallel to the f loor .