BETCO CCRRSS2288, Operator'S Manual, Page: 78 / 91

rc2202rev06-gb Data 12/00 - GG Rev. 06 03/03 - MZ Page 9 of 15
WHEN THE CHOPPER MEMORY HAS LOST THE DATES:
1. Select with ROLL "RESTORE PARAM." = RE-PROGRAMMING OF THE
CHOPPER-PARAMETERS.
* SELECT MENU *
4 - RESTORE
2. Press ENTER.
3. It appears the code of the program 03
SELECT PROGRAM
Mod. 03
4. Press ENTER in order to confirm the loading of the program.
5. It appears the request to confirm the operation
ENTER=YES, OUT=NO
ARE YOU SURE?
YES=ENTER NO=OUT
6. Press ENTER to confirm the loading operation.
7. It appears the message WAIT.
WAIT!
8. At the end of the operation appears again the description "RESTORE”
* SELECT MENU *
4 RESTORE
9. With ROLL select "PROGRAM".
* SELECT MENU *
1 PROGRAM
10. Press ENTER and verify passing the values with ROLL, if they
correspond to the table at page 12 and save at the end, if
parameters were changed
PROGRAMMING VOLTAGE PEDAL ACCELERATOR:
1. Scroll with the button ROLL UP from "PROGRAM" to "PROGRAM
VACC".
* SELECT MENU *
6 PROGRAM VACC
2. It appears the selected menu "PROGRAM VACC".
3. Press ENTER to accede in the menu "PROGRAM VACC".
4. It appears the actual max. values regarding forward and reverse
gear.
FORW BACK
4,9 4,9
5. Press ENTER in order to reset the saved values.
6. The chopper is now prepared to load new min. and max. values,
which will be signalised from the potentiometer.
FORW BACK
0.0 0.0
7. Select with the gear manipulator the forward gear and press the
pedal. Take care to move the pedal slowly at the beginning and to
move it until the end (ONLY EVENT, IN WHICH THE MACHINE DOES
NOT MOVE WITH INSERT GEAR)
8. Repeat this operation with the reverse gear.
9. On the display appear the new MIN and MAX values with reference to
the directions (or similar values).
FORW BACK
4,9 4,9
10. Press ENTER.