Betafence R2000, Installation Manual

Page: 29 / 40

29
Robusta SC
3) At both sides of the motor have we a motor plate support.
These are mounted with four screws on the base plate of the guiding
post. It’s depend on the motor height how much brackets that we use
between base plate and motor plate support.
Each screw has a nut under and above the motor plate support.
With these screws can you regulate the height of the motor.
The space between dental wheel and dental rack must be around 1.5
mm.
Always place the motor on a horizontally level with a spirit level.
4)
Pull the lever operated release system out the motor.
Now is the gate in Manuel mode.
5) Move the wing over the complete length of movement observing the
dental wheel and rack.
Should meshing problems occur in certain positions, these can be
regulated by either moving the dental rack up or down on the under-
beam (oblong holes).