22
Robusta SC
4.6.
Alignment and leveling of
the gate:
1)
First put the gate in manual mode by
disconnecting the motor with the lever
operated release system.
2)
Position the wing such that the rear roller
assembly and guide post support it. Place a spirit
level between the two sets of rollers. Adjust the
level of the wing by means of the rear roller
assembly ground anchor nuts. Keep the base
plate level.
WARNING!
DO NOT ADJUST THE M10 NUTS AND BOLTS
WHICH SECURE THE ROLLER ASSEMBLY TO
THE BASE PLATE:
3)
Align the rear guiding wheels, the guiding post
according the gate center line. Make sure that the
wing is running parallel in the guiding post.
4)
The guiding post and the rear guiding wheels can
be moved laterally in the sleeves of the base
plates.
5)
When the alignment between the rear guiding
wheels and the guiding post (A) is done tighten
slightly the nuts of the ground anchors of the
guiding post and the rear guiding wheels.
6)
Check if the gate moves easy by hand over the
complete route of the wing during opening and
closing. Do this in slow motion as not all
adjustments are done.
Summary of Contents for R2000
