Sewing preparation
52
> Attach the empty bobbin on the winding unit (1) so that the silvery sensor surface is down.
1
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the thread pretension clockwise (3).
> Wind the thread clockwise 2 to 3 times around the empty bobbin (4).
2
3
4
> Pull the excess thread over the thread cutter at the engaging lever (5) and cut.
5
> Push the engaging lever (6) towards the bobbin.
6
– The machine winds and the display to wind the bobbin appears.
> Move the slide on the display using the touchscreen pen/finger to adjust the winding speed.
> To stop the winding process, the engaging lever must the pressed to the right.
> Push the engaging lever towards the bobbin again to continue the winding process.
– As soon as the bobbin is full, the machine stops the winding process automatically.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
Threading the bobbin thread
Prerequisite:
• The needle is raised.
• The machine is switched off and the bobbin cover is opened.
