Bercomac Northeast 700576, Owner'S Manual

Page: 24 / 44

22
STORAGE
a) Clean snowblower thoroughly and repaint all
parts from which paint has worn.
b) List the replacement parts that will be needed to
be replaced before the next season.
c) Follow the instructions in the Lubrication section.
d) Store the snowblower in a dry place.
SNOWBLOWER DISMOUNTING
a) Remove the hair pin and the handle from the chute
rotation.
b) Remove the belt guard.
c) Unhook the winch cable from the snowblower.
d) Release the tension on the belt by displacing the
tension arm backwards. Remove the belt from the
engine pulley under the tractor.
e) Remove the snowblower by activating the latch of
the female hitch.
f) Reinstall the belt guard.
DISMOUNTING & STORAGE
DRIVE MECHANISM DISMOUNTING
a) Dismount the attachment.
b) Remove the rear counterweight when you remove
the front attachment (if applicable).
c) Remove the belt from the engine pulley.
d) Dismount
the drive mechanism by supporting it in
hand. Carefully lower to the ground.
Manual clutch activated by cable:
Unhook cable shield by removing the hair pin.
Unhook spring. Pull out drive mechanism from
underneath tractor.
e) You may leave the subframe on tractor all year long
or remove it if preferred.
f) Reinstall mower if needed.
CAUTION
The belt tension is spring loaded & needs to be
held firmly while displacing to prevent injury
.
WARNING
Never use the snowblower without the belt guard.