16
INSTALLATION
STEP 5
SNOWBLOWER INSTALLATION:
You must install the subframe and drive mechanism
before continuing to install the snowblower.
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the lock (item 1).
Install belts.
NOTE:
See the belt installation instructions in the
Maintenance section.
Insert the snowblower in the lock.
Install the cable
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
CAUTION
The belt tension arm & needs to be held firmly while
displacing to prevent injury
.
CAUTION
Never use the snowblower without the belt guard.
After installing the belt, hook the winch cable (item 1)
to the hook (item 2) and secure with a 2.5mm hair pin
(item 3).
Familiarize yourself with the winch control and make
sure the cable stays wrapped from the bottom of the
drum of the winch. See picture of the winch in the
subframe section.
Lift and lower the snowblower using the switch.
When lowering the accessory, release the switch of
the winch control as soon as the accessory touches
the ground.
Summary of Contents for Northeast 700576
Page 28: ...26 PARTS BREAKDOWN CHUTE...
Page 30: ...28 PARTS BREAKDOWN SNOWBLOWER...
Page 34: ...32 PARTS BREAKDOWN NORTHEAST DRIVE MECHANISM...
Page 36: ...34 PARTS BREAKDOWN SUBFRAME...
