Bercomac Northeast 700576, Owner'S Manual

Page: 8 / 44

6
ASSEMBLY
Install the supports (item 5) on each side of the
vehicle.
Item # Description Action
1 Carriage bolt,
3/8 x 1’’ (qty 6)
Insert as shown.
2 Carriage bolt,
5/16 x 1’’ (qty 2)
Insert as shown.
* 3
Flat washer 1/2’’,
(qty 6)
See*
4 Flat washer 7/16’’,
(qty 2)
Insert on
carriage bolt
(item 2)
5 Support
(qty 2)
Install on the
bolts as shown.
6 Flange nut 3/8’’,
(qty 6)
Do not tighten
now.
7 Flange nut 5/16’’,
(qty 2)
Do not tighten
now.
* For tractors with a engine mounting plate use only
two washers. Do not use washer A.
* For tractors without an engine mounting plate use
all three washers.
IMPORTANT: TORQUE ALL BOLTS ACCORDING
TO TORQUE SPECIFICATION TABLE WHEN
STATED: TIGHTEN FIRMLY.
THE WINCH KIT IS TO BE USED ONLY TO LIFT
BERCO ACCESSORIES, ANY OTHER USE MAY
CAUSE DAMAGE TO THE VEHICLE.
This subframe may be used to install different
attachments (see attachments page). Once installed,
it may remain permanently on your vehicle.
NOTE: It is not necessary to remove mower deck at
this step.
STEP 1
SUBFRAME INSTALLATION:
Refer to parts breakdown section for parts
identification.
TOOLS REQUIRED:
Wrenches: 5/16, 7/16, 9/16, 1/2, 10mm
Ratchet
Sockets: 9/16, 1/2
Pliers
Square head screwdriver: #2
1 wrench (for the nuts on the battery posts of the
vehicle)
Optional tools according to the year of the
vehicle:
Drill
Bit: 13/32
Punch
Hammer
Please sort out and identify all the hardware before
starting installation. Lists for the hardware bag and for
the box are supplied in each.
Install the supports