14
ASSEMBLY
INSTALLING THE SPRING AND
ADJUSTING THE LIFTING HEIGHT OF
THE SNOWBLOWER.
IMPORTANT:
It is very important that the snowblower engine does
not come into contact with the vehicle.
If necessary, use on each side one or two shims (item
2) supplied with the kit to limit the lifting height.
Secure in place with a hex bolt 3/8’’ x 1 1/2’’ (item 3),
a flat washer 7/16’’ (item 4) and a nylon insert lock nut
(item 5) as shown.
Lift the snowblower to its maximum height, insert the
spring (item 1) in the chain (item 6) and on the welded
rod (item 7) as shown.
Install the spring
VERIFYING THE ASSEMBLY
THE LENGTH OF THE SUBFRAME
When the vehicle is advancing in a straight line,
make sure the wheels of the subframe do not come
into contact with the wheels of the vehicle.
When the snowblower is raised to its maximum,
make sure the snowblower engine does not come
into contact with the vehicle.
PRESSURE OF THE TIRES ON THE
SUBFRAME
Verify and adjust the pressure of the tires of the
subframe at 50 psi.
The tire pressure must be even on both sides.
