12
ASSEMBLY
CONTROL BOX INSTALLATION:
Install the control box
Thread the other wire by an appropriate route to the
battery.
Connect the red wire (item 1) to the positive post and
the black wire (item 2) to the negative post on the
vehicle's battery or on the vehicle's frame (Scratch
away some paint on the frame to ensure a good
contact.
NOTE:
Secure the wires to the vehicle with the nylon
tie wraps. These wires will stay on the vehicle.
IMPORTANT:
The control box is equipped with a red
emergency kill switch in case you need to stop the
engine quickly.
NOTE:
The emergency kill switch must be pulled out
to start the engine of the accessory.
Connect the wires on the battery
Disconnect the wires that are connected to the
control box (item 3).
Install the box support (item 1) in an appropriate
place . Drill holes if necessary. Secure the box
support with the two 1/4’’ x 1/2’’ hex bolts and flange
nuts.
Tighten firmly.
Install the control box on the box support.
Thread the wires that unites the accessory under the
hood to the front of the vehicle.
