13
ASSEMBLY
Wires for the control box:
Connect the red wire (item 1) to the positive post and
the black wire (item 2) to the negative post on the
vehicle's battery.
NOTE: Secure the wires to the vehicle with the nylon
tie wraps. These wires will stay on the vehicle.
IMPORTANT: The control box is equipped with a red
emergency kill switch (item 3) in case you need to
stop the engine quickly.
NOTE: The emergency kill switch must be pulled out
to start the engine for the broom.
Install the wires of the control box
STEP 5
INSTALLATION OF THE WIRES FOR THE
ELECTRIC STARTER:
Wires for the electric starter:
C o n n e c t
t h e
w i r e
a s s e m b l y
( i t e m
1) on the ATV’s battery, the longest red wire (positive)
(item 1) on the positive post as shown.
Connect the black wire (negative) (item 3) on a bolt
that is on the A.T.V’s. frame (scrape away any paint
to make sure the contact is good) and retighten the
bolt.
Connect the electric starter wire assembly to the wire
assembly on the battery.
NOTE: Attach the wires to the vehicle with the nylon
tie wraps. These wires will stay on the vehicle.
Install the wires for the electric starter