9
ASSEMBLY
Install the wheel support
Install the assembled turnbuckles
Install broom to subframe
STEP 3
SUBFRAME PREPARATION:
NOTE: Determine according to the height of the
vehicle which set of holes to use to assemble the
wheel support (item 1) to the subframe* (See below).
Install the wheel support (item 1).
# Item
Description
Action
1
Wheel support
Install to the
subframe.
2
Hex bolt
3/8" x 1"(qty 4)
Insert as shown.
3
Flange nut 3/8"
(qty 4)
Tighten firmly.
*The subframe must be parallel with the ground when
the subframe is installed under the vehicle.
Install the assembled turnbuckles (item 1).
# Item
Description
Action
1
Assembled
turnbuckle (qty 2)
Install on subframe as
shown.
2
Flat washer 3/8"
(qty 2)
Install on the
assembled
turnbuckles as shown.
3
Hex bolt
5/16" x 1"(qty 2)
Insert as shown.
4
Nylon insert lock nut
5/16" (qty 2)
Install and tighten
firmly.
NOTE: Position the chains as shown and tighten
firmly.
Install the broom to the subframe.
# Item
Description
Action
1
Hair pin
4mm
Remove from pin
(item 2).
2
Pin
Remove as shown.
Install the broom’s push frame to the subframe.
Secure with the pin and hair pin previously removed.
NOTE: The hooked end of the pin must be inserted
into the hole to lock it in place.