Operation
29
In some cases, you may need to optimize the
picture quality. To do this, press AUTO on
the projector or remote control. Within 5
seconds, the built-in Intelligent Auto
Adjusent function will re-adjust the values of
Frequency and Clock to provide the best
picture quality.
• The screen will display "Auto
adjusting" while AUTO is
functioning.
• This function is only available when PC signal (analog RGB) is selected.
Correcting 2D keystone
2D Keystone function enables a wider projector installation area compared to
conventional projectors with limited positioning in front of the screen.
To correct this, you will need to manually correct it following one of these steps.
• Using the projector or remote control
Press
/ / / to display the Keystone
page. Press / to adjust vertical values from -30 to 30.
Press / to adjust horizontal values from -25 to 25.
• Using the OSD menu
1.
Press Menu/Exit and select the DISPLAY
menu.
2.
Press to select Keystone and press Mode/
Enter.
3.
Press / / / to adjust the keystone values.
• Using the QUICK INSTALL key
1.
Press QUICK INSTALL on the remote control.
2.
Press to select Keystone and press Mode/
Enter.
3.
Press / / / to adjust the keystone values.
